With our Plug and Play mains priority circuit, you can integrate your power station (Ecoflow, Jackery, etc.) into your Grand California within minutes.

To do this, a plug is pulled from the original 230-volt fuse box of your Grand California and connected to our Plug and Play module. In the next step, you connect the power station to our module via the integrated IEC connector, and the power supply is ready.

The best part: If you connect your Cali to shore power, the power station will automatically charge via it, and the power supply will switch internally so that the sockets function normally again via shore power. If the shore power connection is disconnected, the power station immediately takes over the 230-volt power supply, fully functional and safe with RCD protection thanks to our circuit in the TN network.

General functionality

With our integration, you have the following options after installation:

1. Your 230-volt sockets in the Grand California can be used as with shore power. Your power station supplies the necessary power, fully functional and safe with RCD protection thanks to our circuit in the TN network. Please note the maximum output power of your power station in any case.
2. Your power station will automatically charge as soon as you connect your vehicle to a shore power connection.
3. If your vehicle is connected to shore power, your power station will be charged by the mains priority circuit as described above. At the same time, your vehicle is supplied directly via shore power, which also charges the leisure battery.

Please note the following point:

• Our module comes with a standard IEC connector for connection to the power station. Depending on the model, it may be necessary to use a different connector. This is the case, for example, with Jackery devices. In this case, the original power supply unit of the power station must be interposed.
• The connection in the fuse box is intended for using the 230-volt sockets and is not intended to charge the leisure battery via the power station. If the module is connected to the input of the original 230-volt distribution, this line and thus also the one to the IEC connector is not fused. There is a risk to life!
• The module is designed for a continuous inverter load of up to 1800 W. Short-term peaks above this are not a problem, but you should adhere to this value in continuous operation. If your power station has more output power, the 1800 W limit of the module still applies.
• We assume no liability for damage caused by incorrect or improper connection.

Technical data: 

• Weight: 2000g 
• Input voltage 230V 
• Maximum power 16 A short-term
• Continuous load up to 1800 W
• Housing protection class IP65
• Connection cable 2x Wago WINSTA® MIDI plug, 1x Schuko plug, 1x IEC socket
• VDE 0100-721 compliant